Shure AVC20 Stereo System User Manual


 
CONNECTION OF
SPEAKERS
Connection of
4
Speakers
OPERATE SWITCH
+I
MONO OUT
I
I
Normally this switch is SPEAKER AC OUTLET
Monophonic Output kept to the left (seen OUTPUT
(SWITCHED)
Terminals from behind). TERMINALS
There
is
one set of four speaker output terminals. Use speakers with an impedance of
8
to
16
ohms.
Connection of Speaker Cables
Normal
Speaker
Connection
1.
If the bare speaker wire is too short, strip off
the vinyl and make the exposed wires the
same length.
lomm
[318'n1
*F
EXAMPLE:
With a speaker terminal on the
bottom side.
2.
Press down the lever and insert the cord. Use a
"+"
terminal for the
+
side of the speaker and
Remove your finger from the lever, and pull
a
"-"
terminal for the
-
side.
on the cord to be sure that
it
is
properly con-
3.
Raise the lever.
nected. Be sure that the wire does not stick out
Put the Operation Switch in the
I
NORMAL
1
from the cord and come into contact with
position.
wire of another cord,
as this may damage the
equipment.