Filter
Top Products
USE
OF
WIRELESS
REMOTE CONTROL
A variety of operations are possible from a comfortable distance when, using the wireless remote
control unit.
Remote Control Sensor
.When using the wireless remote control,
always point it toward the remote control
sensor on the
AVC20.
This wireless remote control unit uses infrared
rays. Exposure of the sensor on the
AVC20
to strong fluorescent light or the like could
result in malfunction. Locate the
AVC20
to minimize exposure to surrounding light.
I
I
.The wireless remote control unit should
be
'
\
used within vertical or horizontal angles of
A~~~~~.
A~~~~~,
approximately
30'
with respect to the sensor 600 meters
on the
AVC20 at a distance up to 7m (20ft).
INSERTING BATTERIES
Remove the cover on the rear.
Insert two size "AA" batteries, pay close
'0
Replace the cover.
attention to the correct polarity
I+
and
-1.
CAUTIONS ON BATTERIES
a
Use size "AA" batteries.
Replace the batteries when distance of ope-
ration decreases.
The replacement interval depends on the
number of times used, but it
is
recommend-
ed that the batteries be replaced at least
once every year.
When not using the remote control unit for
an extended period of time, remove the
batteries.
Do not use an old battery with a new one or
two batteries of different types (for example,
one dry cell and one alkaline battery), as this
may result in leakage or damage to the unit.
Should leakage occur, wipe thoroughly and
insert new batteries.
Do not short circuit, disassemble, or throw
batteries into flames.
Do not place objects on top of the remote
control unit, as the batteries will wear out if
a
key
is
held down.
Always strictly observe cautions written on
batteries.
Do not dispose of batteries together with
flammable garbage (where applicable).