Filter
Top Products
ENGLISH
57
ENGLISH
SETTING THE CH LEVEL SETUP
■Note :
• Depending on the speaker settings("NO", etc.), some
channels cannot be selected.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory
("CALIBRATE"), not into preset memory("REFERENCE 1", "REFERENCE 2").
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes.(For details, refer to "Adjusting each channel level with test tone" on page 26.)
• The LFE level can be adjusted within the range of -10 ~ 0 dB
and other channel levels within the range of -15 ~ +15 dB
• In general, we recommend the LFE level to be adjusted to 0
dB.(However, the recommended LFE level for some early
DTS software is -10 dB.) If the recommended levels seem too
high, lower setting as necessary.
Adjusting the current channel level
■When adjusting the LFE LEVEL
①. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the LFE LEVEL SETUP, then press the ENTER
button.
②. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired program source.
Memory mode
1. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired channel.
3. Repeat the above steps 1 and 2 to adjust each channel level.
2. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to adjust the level of the selected channel or program
source's LFE as desired.
RD-7503(A) 2008.11.4 1:45 PM 페이지 57