Filter
Top Products
ENGLISH
55
• You can adjust the crossover frequency within the range
of 40 ~ 250 Hz.
• Select "FULL RANGE" when the selected speaker can
fully reproduce the low frequencies below 40 Hz.
When selecting the SPEAKER CROSSOVER
Note :
• You cannot select the subwoofer and the speakers set to
"NO".
• Set the crossover frequency according to the frequency characteristics of the speakers connected.
(For details on the frequency characteristics, refer to the operating instructions of the speakers.)
• If the frequency range of your speaker is 100 Hz ~ 20 kHz, the crossover frequency should be set to 100 Hz (or slightly
higher).
• The low frequencies below the crossover frequency are to output from subwoofer or the speakers which are set to "FULL
RANGE" (when not using a subwoofer).
1. Press the CURSOR UP()/DOWN() buttons to select the SPEAKER CROSSOVER, then press the
ENTER button.
2. Press the CURSOR UP()/DOWN() buttons to select the desired speaker.
3. Press the CURSOR LEFT()/RIGHT() buttons to set the crossover frequency as desired.
4. Repeat the above steps 2 and 3 until the crossover frequencies are all set as desired.
RD-7503(A) 2008.11.4 1:45 PM 페이지 55