Filter
Top Products
ENGLISH
38
ROOM 2 SOURCE PLAYBACK
• This function allows enjoying one source in the main room and playing another in a different room at the same time.
Notes:
• The analog signals from the EXTERNAL INs and the digital signals cannot be output to the different room, meaning no
playback in a different room.
• Only the (composite) video signals can be output to the different room.
Notes:
• When the EXTERNAL IN is selected as a main input, if the MAIN source is selected as a ROOM 2 input, no audio signal can be
heard in the different room (ROOM 2).
• Even when this receiver enters the standby mode, in such a case that "R2" lights up still and the STANDBY indicator lights up
blue as it does in the operating mode, meaning only the ROOM 2 circuitry operates, the ROOM 2 source can be played
independently.
• When you do not use the ROOM 2 function, turn off the ROOM 2 function to save electricity.
• ROOM 2 ~ is displayed for several seconds.
• When the ROOM 2 setting mode disappears, press the
ROOM 2 button again.
• Each time these buttons are pressed, the mode changes
as follows :
ROOM 2 ~ : To turn on or off the ROOM 2 function.
(ROOM 2 mode)
IN ~ : To select the desired ROOM 2 source.
(ROOM 2 input)
VOL ~ : To adjust the volume on the power
(ROOM 2 volume) amplifier assigned to "BACKROOM
2" or "ROOM 2".
Note :
• When the ROOM 2 mode is set to OFF, the ROOM 2
input and the ROOM 2 volume cannot be selected.
When selecting the ROOM 2 mode.
ON : To turn on the ROOM 2 function.
("R2" lights up.)
OFF : To turn it off. ("R2" goes off.)
• You can also set the ROOM 2 mode to ON or OFF with
pressing the ROOM 2 button on the remote control.
When selecting the ROOM 2 input.
• You can select the desired among MAIN source, TUNER,
CD, F.AUX, TAPE, BT(Bluetooth IN), VIDEO 1 ~ VIDEO
3 as a ROOM 2 source.
When selecting the ROOM 2 volume.
• You can adjust the volume on the power amplifier
assigned to "BACKROOM 2" or "ROOM 2" when
the ROOM 2 speaker terminals are connected to the
speakers in a different room. (For details, refer to "When
selecting the AMP ASSIGN" on page 41.)
1. Press the ROOM 2 button to enter the ROOM 2
mode.
3. Set the selected mode as desired.
4. Start play on the component related to the
ROOM 2 source.
2. Select the desired mode while displaying the
ROOM 2 setting mode.
RD-7503(A) 2008.11.4 1:45 PM 페이지 38