Filter
Top Products
ENGLISH
53
When selecting the SPEAKER CONFIGURATION
1. Press the CURSOR UP()/DOWN() buttons to select the SPEAKER CONFIGURATION, then press the
ENTER button.
2. Press the CURSOR UP()/DOWN() buttons to select the desired speaker.
Continued
YES/NO: Select the desired depending on whether the
speakers are connected or not.
2CH/1CH: Select the desired depending on the number of
speakers connected to SURROUND BACK/
MULTI channels.
Notes :
• When speakers are not set to "NO", you should set their distances from listening position and crossover frequencies
according to their frequency characteristics. (For details, refer to "When selecting the SPEAKER DISTANCE" on page 54
and "When selecting the SPEAKER CROSSOVER" on page 55.)
• When the "SURROUND" is set to "NO", "BACK/MULTI" cannot be set to "2CH" or "1CH".
• When the surround back channels' power amplifier is assigned to "BI-AMP" or "ROOM 2", the "BACK/MULTI" cannot be
selected. (For details, refer to "When selecting the AMP ASSIGN" on page 41.)
3. Press the CURSOR LEFT()/ RIGHT( buttons to set the selected speaker as desired.
4. Repeat the above steps 2 and 3 until the speakers are all set as desired.
RD-7503(A) 2008.11.4 1:45 PM 페이지 53