Filter
Top Products
ENGLISH
42
When selecting the SUBWOOFER MODE
• "SW PLUS" mode is valid only when "FRONT" and "CENTER" are set to "FULL RANGE" and "SUBWOOFER" is set to
"YES" on the SPEAKER/ROOM EQ SETUP menu. (For details, refer to "SETTING THE SPEAKER/ ROOM EQ SETUP" on
page 51.)
NORMAL : When the low frequency signals of channels set to "FULL RANGE " are reproduced from those channels only. In
this mode, the low frequency signals that are reproduced from the subwoofer channel is only the low frequency
signals of LFE (from the multi-channel sources that contains LFE (Low Frequency Effects) channel, also called
the ".1" channel) and the channels set to the setting value other than "FULL RANGE".
SW PLUS : When the low frequency signals of channels set to "FULL RANGE" are reproduced simultaneously from those
channels and the subwoofer channel.
In this mode, the low frequency range expands more uniformly through the room, but depending on the size
and shape of the room, interference may result in a decrease of the actual volume of the low frequency range.
When selecting the HDMI AUDIO OUT
• The HDMI connection can carry uncompressed digital video signals and digital audio signals.
Depending on whether the digital audio signals input into the HDMI IN are output from the HDMI MONITOR OUT of this
receiver or not, you should set the HDMI AUDIO OUT correctly.
OFF : Not to output the HDMI digital audio signals from the HDMI MONITOR OUT of this receiver, meaning these
signals are heard from the speakers connected to this receiver.
ON : To output the HDMI digital audio signals from the HDMI MONITOR OUT, meaning these signals are heard from the
speakers of your TV.
Note:
• When the HDMI AUDIO OUT is set to ON, no sound will be heard from the speakers connected to this receiver (except ROOM
2 speakers) even though any input source is selected.
When selecting the TONE CONTROL
OFF : To listen to a program source without the tone effect. ("DIR" lights up.)
ON : To adjust the tone for your taste. ("DIR" goes off.)
When the TONE CONTROL is set to ON to adjust the tone (bass and treble)
. Press the ENTER button to enter the tone adjustment mode.
Continued
RD-7503(A) 2008.11.4 1:45 PM 페이지 42