Filter
Top Products
62
ENGLISH
• Loud test tones are output successively and then if a series of auto setup procedure has been completed,
"COMPLETED" will be displayed.
• To stop the auto setup procedure while performing it, press the ENTER button.
In such a case that the auto setup procedure is stopped before "COMPLETED" is displayed, the results of
each adjustment can not be memorized.
• If there may be a problem with speaker or microphone connection, error message will be displayed. In this case,
turn off the power, check the connection and then retry the auto setup procedure.
Notes :
• Because the test tones are loud, ensure there no infants or small children in the room.
• For best results, ensure the room is as quiet as possible during the auto setup procedure.
If there is too much ambient noise, the results may not be satisfactory.
When the auto setup has been completed.
Continued
2. Press the CURSOR UP( )/DOWN( ) buttons to select the AUTO SETUP, then press the ENTER button.
3. Press the CURSOR UP( )/DOWN( ) buttons to select the START, then press the ENTER button.
4. To memorize the results, press the CURSOR LEFT( )/ RIGHT( ) buttons to select the APPLY, then press
the ENTER button.
• Then the results are memorized and the SPEAKER/
ROOM EQ SETUP menu is displayed.
• Each time the CURSOR LEFT( )/ RIGHT( ) buttons are
pressed, the APPLY or the CANCEL is selected.
• When the CANCEL is selected, the results are not
memorized.
• Check the results on each setup menu(SPEAKER CONFIGURATION menu on page 63, SPEAKER
DISTANCE menu on page 64, SPEAKER CROSSOVER menu on page 65 and CH LEVEL SETUP menu for
"CALIBRATE" mode on page 67).
• If the results are not satisfactory, you can retry the auto setup procedure or personalize your speaker setup
and channel level setup by making the settings manually. (For details, refer to "When selecting the
SPEAKER CONFIGURATION" on page 63, "When selecting the SPEAKER DISTANCE" on page 64, "When
selecting the SPEAKER CROSSOVER" on page 65, "Adjusting each channel level with test tone" on page
37 and "Adjusting the current channel level" on page 38.)