Filter
Top Products
ENGLISH
49
ENGLISH
Notes:
• When the EXTERNAL IN is selected as a main input, if the MAIN source is selected as a ROOM 2 input, no
audio signal can be heard in the different room (ROOM 2).
• Even when this receiver enters the standby mode, in such a case that " " lights up still and the
POWER ON/STANDBY button lights up blue as it does in the operating mode, meaning only the ROOM 2
circuitry operates, the ROOM 2 source can be played independently.
• When you do not use the ROOM 2 function, turn off the ROOM 2 function to save electricity.
• ROOM 2 ~ is displayed for several seconds.
• When the ROOM 2 setting mode disappears,
press the ROOM 2 button again.
• Each time these buttons are pressed, the mode
changes as follows :
ROOM 2 ~ : To turn on or off the ROOM 2
(ROOM 2 mode) function.
INPUT ~ : To select the desired ROOM 2
(ROOM 2 input) source.
VOLUME ~ : To adjust the volume on the
(ROOM 2 volume) power amplifier assigned to
ROOM 2.
Note :
• When the ROOM 2 mode is set to OFF, the
ROOM 2 input and the ROOM 2 volume cannot be
selected.
When selecting the ROOM 2 mode.
ON : To turn on the ROOM 2 function.
(" " lights up.)
OFF : To turn it off. (" " or " "
goes off depending on the AMP ASSIGN
setting.)
When selecting the ROOM 2 input.
• You can select the desired among MAIN source,
TUNER, CD, AUX, TAPE, VIDEO 1 ~ VIDEO 4
as a ROOM 2 source.
When selecting the ROOM 2 volume.
• You can adjust the volume on the power amplifier
assigned to "BACK ROOM 2" or "ROOM 2"
when the ROOM 2 speaker terminals are
connected to the speakers in a different room.
(For details, refer to "When selecting the AMP
ASSIGN" on page 52.)
1. Press the ROOM 2 button to enter the ROOM 2
mode.
3. Set the selected mode as desired.
4. Start play on the component related to the
ROOM 2 source.
2. Select the desired mode while displaying the
ROOM 2 setting mode.
When using the buttons on the front panel
Continued