Filter
Top Products
54
ENGLISH
When selecting the USER mode
• You can adjust the parametric EQ settings to optimize the frequency characteristics of this unit's parametric
equalizer to match the acoustic characteristics of your room.
• The parametric equalizer uses a combination of the following three parameters to provide highly precise
adjustment of the frequency characteristics.
Frequency
• This unit has 5 equalizer bands for each channel. You can adjust the specified frequency bands each
within the following frequency ranges :
20 Hz ~ 120 Hz, 130Hz ~ 500 Hz, 550 Hz ~ 1.9 kHz, 2 kHz ~ 7.5 kHz, 8 kHz ~ 20 kHz
Gain
• This parameter is adjustable within the range of -24 ~ +24 dB in 1 dB intervals.
Q factor
• The width of the specified frequency band is referred to as the Q factor. This parameter is adjustable within
the range of 0 ~ 24 in 1 intervals.
Notes :
• When selecting the mode other than "USER" mode, you cannot select the EQ parameters for each channel.
• You cannot select the channel of the subwoofer and the speakers set to "NO".
. Press the CURSOR UP()/DOWN() buttons to select the CHANNEL, then press the CURSOR
LEFT()/RIGHT() buttons to select the desired channel.
. Press the CURSOR UP()/DOWN() buttons to select the parameter mode, then press the CURSOR
LEFT()/RIGHT() buttons to select the Fc (Frequency) mode.
. Press the CURSOR UP()/DOWN() buttons to select the desired frequency band, then press the
CURSOR LEFT()/RIGHT() buttons to select the desired frequency.
. Repeat the above step until the desired frequency is selected for each frequency band.
. Repeat the above steps ~ to adjust the gain of each specified frequency band.
. Repeat the above steps ~ to adjust the Q factor of each specified frequency band.
. Repeat the above steps ~ until the EQ parameters of other channels are all adjusted as desired.
Continued
R-772(G) 2007.9.17 4:43 PM 페이지 54