Filter
Top Products
ENGLISH
11
• ROOM 2 playback feature allows you to play a different program source in another room as well as one source
in the main room at the same time.
• For ROOM 2 playback, connect the ROOM 2 OUT jacks to the amplifier, TV, etc. installed in another room, or
connect the ROOM 2 speaker terminals to the speakers.
• Because this receiver cannot drive the surround back speakers and the ROOM 2 speakers simultaneously, you
should assign their power amplifier correctly depending on how to use them. (For details, refer to "When
selecting the AMP ASSIGN" on page 40.)
• When the ROOM 2 (AUDIO) OUT jacks are not connected to the ROOM 2 amplifier, you can connect these
jacks to audio recording equipment such as a tape deck, an MD recorder, etc. for analog audio recording. (For
details, refer to "CONNECTING AUDIO COMPONENTS" on page 7.)
Notes :
• To minimize hum or noise, use high quality connection cords.
• You cannot use the digital audio signal for ROOM 2 playback.
• This receiver incorporates USB as well as RS-232C terminal
that may be used in the future to update the operating
software so that it will be able to support new digital audio
formats, external control by using an external device and the
like.
• Connect either USB or RS-232C terminal to your PC (you
don't need to do both).
Notes:
• Programming for upgrades and external control requires
specialized programming knowledge and for that reason we recommend that it only be done by qualified
installers. For more information on future upgrades and external control, visit the Sherwood web site at
www.sherwoodamerica.com or contact your dealer.
• Do not disconnect the connection cable while updating the operating software, etc.
Should this happen, it may be result in malfunction or cause damage to the unit.
9. CONNECTING ROOM 2 OUTS
10. CONNECTING PC FOR UPGRADES
R-772(G) 2007.9.17 4:43 PM 페이지 11