Filter
Top Products
ENGLISH
28
Adjusting the current channel level
• Each time these buttons are pressed, the
corresponding channel is selected as follows:
( ): Possible depending on whether the surround back channel is
set to "2 CH" or "1 CH".
< >: Possible only when the digital signals from Dolby Digital or
DTS program sources that include LFE signal are input.
• Depending on the speaker settings("NO", etc.)
and surround mode, etc., some channels cannot
be selected.
• When the SPEAKER button is set to off, only the
Front Left, Front Right (and LFE) channels can
be selected.
• After adjusting each channel level with test tone, adjust the channel levels either according to the program
sources or to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s
memory ("CAL"), not into preset memory("REF 1", "REF 2").
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the
range of -15~+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended
LFE level for some early DTS software is -10 dB.)
If the recommended levels seem too high, lower
the setting as necessary.
• Then the memory mode ("CAL" or "REF 1") is
displayed for several seconds.
• When the memory mode or channel level
disappears, press this button again.
1. Press the CHANNEL LEVEL button.
3. Adjust the level of the selected channel as
desired.
4. Repeat the above steps and 3 to adjust each
channel level.
2. Select the desired channel.
R-772(G) 2007.9.17 4:43 PM 페이지 28