Filter
Top Products
ENGLISH
52
• You can adjust the crossover frequency within the
range of 40 ~ 250 Hz.
• Select "FULL RANGE" when the selected speaker
can fully reproduce the low frequencies below 40 Hz.
When selecting the SPEAKER CROSSOVER
Note :
• You cannot select the subwoofer and the speakers
set to "NO".
• Set the crossover frequency according to the frequency characteristics of the speakers connected.
(For details on the frequency characteristics, refer to the operating instructions of the speakers.)
• If the frequency range of your speaker is 100 Hz ~ 20 kHz, the crossover frequency should be set to 100 Hz
(or slightly higher).
• The low frequencies below the crossover frequency are to output from subwoofer or the speakers which are
set to "FULL RANGE" (when not using a subwoofer).
1. Press the CURSOR UP()/DOWN() buttons to select the SPEAKER CROSSOVER, then press the
ENTER button.
2. Press the CURSOR UP()/DOWN() buttons to select the desired speaker.
3. Press the CURSOR LEFT()/RIGHT() buttons to set the crossover frequency as desired.
4. Repeat the above steps and 3 until the crossover frequencies are all set as desired.
R-772(G) 2007.9.17 4:43 PM 페이지 52