Filter
Top Products
ENGLISH
22
LISTENING TO A PROGRAM SOURCE
Operations
Before operation
• Enter the standby mode.
• The POWER ON/STANDBY button
lights up amber. This means that the
receiver is not disconnected from the
AC mains and a small amount of
current is retained to support the
operation readiness.
• To switch the power off, push the
POWER switch again.
Then the power is cut off and the
POWER ON/STANDBY button goes off.
• Then the SPEAKER indicator lights up
and the sound can be heard from the
speakers connected to the speaker
terminals.
• When using the headphones for private
listening, press the SPEAKER button
again to switch the speakers off.
• Each time the "AUDIO" button on the front panel
is pressed, the input source changes as follows:
CD AUX TAPE
• Each time the "VIDEO" button on the front panel
is pressed, the input source changes as follows:
VIDEO 1VIDEO 2VIDEO 3 VIDEO 4
• Each time the "TUNER" button is pressed, the
band changes as follows:
FM STereo FM MONO AM
When selecting the EXTERNAL IN as desired,
• Depending on the power amplifier setting for the
surround back channels and the surround back
speaker setting, "EXT. IN" is displayed and 8(/7/6)
separate analog signals from the component
connected to this input pass through the tone and
volume circuits only and can be heard from your
speakers.
• Select the desired input source to cancel the
external in function.
• These analog signals can be heard only, not
recorded.
Notes:
• Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page
15 for details about operation.
• Before operating this receiver, first set this unit as desired for optimum performance, doing the OSD menu
setting procedures. (For details, refer to "OSD Menu Settings" on page 38.)
• Each time the POWER ON/STANDBY button on
the front panel is pressed, the receiver is turned on
to enter the operating mode (the POWER ON/
STANDBY button lights up blue) or off to enter the
standby mode(the POWER ON/STANDBY button
lights up amber).
• On the remote control, press the POWER ON
button to enter the operating mode or press the
STANDBY button to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR
button is pressed, the receiver is turned on
automatically and the desired input is selected.
1. In the standby mode, turn the power on.
3. Select the desired input source.
2. Switch the speakers on.
R-772(G) 2007.9.17 4:43 PM 페이지 22