Filter
Top Products
ENGLISH
49
• Loud test tones are output successively and then if a series of auto setup procedure has been completed, "COMPLETED"
will be displayed.
• To stop the auto setup procedure while performing it, press the ENTER button.
In such a case that the auto setup procedure is stopped before "COMPLETED" is displayed, the results of each adjustment
may not be memorized.
• If there may be a problem with speaker or microphone connection, error message will be displayed. In this case, turn off the
power, check the connection and then retry the auto setup procedure.
Notes :
• Before starting auto setup, be sure not to set the HDMI AUDIO OUT to ON.
• Because the test tones are loud, ensure there no infants or small children in the room.
• For best results, ensure the room is as quiet as possible during the auto setup procedure.
If there is too much ambient noise, the results may not be satisfactory.
When the auto setup has been completed.
Continued
2. Press the CURSOR UP()/DOWN() buttons to select the AUTO SETUP, then press the ENTER button.
3. Press the CURSOR UP()/DOWN() buttons to select the START, then press the ENTER button.
4. To memorize the results, press the CURSOR LEFT()/ RIGHT() buttons to select the APPLY, then press
the ENTER button.
• Then the results are memorized and the SPEAKER/ ROOM EQ SETUP
menu is displayed.
• Each time the CURSOR LEFT()/ RIGHT() buttons are pressed, the
APPLY or the CANCEL is selected.
• When the CANCEL is selected, the results are not memorized.
• Check the results on each setup menu(SPEAKER CONFIGURATION
menu on page 50, SPEAKER DISTANCE menu on page 51, SPEAKER
CROSSOVER menu on page 52 and CH LEVEL SETUP menu for
"CALIBRATE" mode on page 55).
• If the results are not satisfactory, you can retry the auto setup
procedure or personalize your speaker setup and channel level setup
by making the settings manually. (For details, refer to "When selecting
the SPEAKER CONFIGURATION" on page 50, "When selecting the
SPEAKER DISTANCE" on page 51, "When selecting the SPEAKER
CROSSOVER" on page 52, "Adjusting each channel level with test
tone" on page 27 and "Adjusting the current channel level" on page 28.)
R-772(G) 2007.9.17 4:43 PM 페이지 49