Filter
Top Products
ENGLISH
23
• When playing back the program sources with
surround sound, refer to “ENJOYING
SURROUND SOUND” on page 26.
• If the AUDIO MODE is set to the mode other
than "DIGITAL" for the corresponding input
source on the INPUT SETUP menu, you cannot
hear the sound from the selected digital input.
(For details, refer to "SETTING THE INPUT
SETUP" on page 44.)
When CD, AUX, VIDEO 1~ 4 is selected as
an input source
Notes:
• When the selected digital input is not connected
or assigned, "o1", "c1", etc. (, meaning no digital
signal input from it) or "d" (, meaning no audio
assignment) flickers and no sound will be heard.
• The selected digital input is automatically
assigned to the corresponding input source on
the INPUT SETUP menu. (For details, refer to
"SETTING THE INPUT SETUP" on page 44.)
• The sound from the component connected to the
selected digital input can be heard regardless of
the selected input source.
• Each time the MULTI CONTROL knob is rotated
or the CURSOR LEFT()/RIGHT() buttons are
pressed, the corresponding input is selected as
follows :
• "AUD ~" is displayed for several seconds.
• "AUD ~" disappears, press the AUDIO ASSIGN
button again.
• Ensure that the SPEAKER button is set to off.
• Depending on the signal format which is being
input, you can listen in Dolby Headphone mode,
stereo mode, etc. (For details, refer to "Listening
in Dolby Headphone mode" on page 27).
• When the EXTERNAL IN is selected as an input
source, only front left and front right channel
signals can be reproduced through the
headphones.
Note:
• Be careful not to set the volume too high when
using headphones.
Muting the sound
Listening with headphones
• "MUTE" flickers.
• To resume the previous sound level, press it again.
4. Press the AUDIO ASSIGN button.
5. Select the desired of the digital inputs connected
while displaying "AUD ~".
6. Operate the selected component for playback.
7. Adjust the (overall) volume.
R-772(G) 2007.9.17 4:43 PM 페이지 23