Filter
Top Products
34
The operating menu
Starting the scan
Scan new Via the “Scan new” menu, you can scan all frequency banks for free
channels. The last scan result is overwritten.
̈ Before starting the scan, switch all transmitters of your system off,
since channels used by switched-on transmitters will not be displayed
as “free channels”.
̈ Turn the jog dial
7 until the arrow points to “Scan new”.
̈ Press the jog dial
7 to start the scan.
The receiver scans the frequency banks one after the other for free
channels. This can take several minutes. After the scan, a table displays
the number of free channels for each frequency bank and the green
backlighting of the save button
8 flashes.
Note:
You can cancel the scan at any time by pressing the esc button
6. The
display changes to the setting mode of the “Scan” menu and the last
scan result is restored.
̈ Turn the jog dial
7 to select a frequency bank with a sufficient number
of free channels.
̈ Press the save button
8.
The selected frequency bank is automatically called up in the “B.Ch”
menu.
̈ Select a channel from this frequency bank (see “Selecting a frequency
bank and a channel” on page 28).
Note:
After the scan, the channels that are occupied or subject to interference
are marked with a warning triangle and the text “Freq. occupied” in the
“Tune” menu.
Channel list
Scan new
Scan reset
esc
save
sync
digital audi
o
processing
sync
D
EV
M
H
z
790.800
03.03
BANK
CH
COM
AF
B.Ch
1.
790.800 MHz
Freq. occupied
EM3732_516551_0108_Sp6.book Seite 34 Dienstag, 18. Dezember 2007 11:55 11