Filter
Top Products
29
The operating menu
The selected frequency bank and the selected channel are set. The
display changes to the selection mode of the operating menu.
Changing the receiving frequency for a selected channel in the
frequency bank “U”
Tune Each receiver has seven frequency banks. The frequency banks “1” to “6”
have up to 60 channels that are factory-preset to a receiving frequency
(see enclosed frequency tables). The frequency bank “U” (user bank) has
60 channels to store your selection of receiving frequencies that can be
freely selected in 5-kHz increments within the switching bandwidth. Via
the “Tune” menu, you can freely select the frequencies to be stored in the
frequency bank “U”.
̈ Change to the setting mode of the “B.Ch” menu and select the
frequency bank “U” and one of the channels “01” to “60” whose
frequency you want to change and store (see “Selecting a frequency
bank and a channel” on page 28).
Note:
The receiving frequencies of the channels in the frequency banks “1” to
“6” cannot be changed. When you have selected one of the frequency
banks “1” to “6” and then select the “Tune” menu, the receiver
automatically switches to channel “01” of the frequency bank “U”.
̈ Change to the setting mode of the “Tune” menu and select the
receiving frequency you want to store (see “Setting the receiving
frequency” on page 28).
The selected receiving frequency is set and stored on the selected
channel of the frequency bank “U”, i.e. the previously stored frequency
is overwritten. The display changes to the selection mode of the
operating menu.
Entering a name
Name Via the “Name” menu, you can enter a freely selectable name for the
receiver. The name can be displayed on the status display and can consist
of up to six characters such as:
y letters (without pronounciation marks),
y number from 0 to 9,
y special characters and spaces.
̈ Change to the setting mode of the “Name”
menu.
The first character of the name starts
flashing.
̈ Select a different character by turning the jog dial
7.
The selected character starts flashing.
̈ Confirm the selected character by pressing the jog dial
7.
The first character is accepted and stops flashing. The next character
starts flashing.
̈ Repeat the last two steps to enter the remaining characters.
̈ After you have entered the six characters of the name, press the save
button
8.
The name is stored. The display changes to the selection mode of the
operating menu.
In order that the name is displayed on the status display, you may have to
change the contents of status display (see “Selecting the status display”
on page 36).
790.
800
MHz
B.Ch
U.01
776
UHF MHz
866
B.Ch
1.
790.800MHz
EL
+,-|/0123456
7 8 9 * ; < = > A A B
CDEFGHIJKLMN
OPQRSTUVWXYZ
esc
save
sync
digital audi
o
processing
sync
D
EV
M
H
z
790.800
03.03
BANK
CH
COM
AF
EM3732_516551_0108_Sp6.book Seite 29 Dienstag, 18. Dezember 2007 11:55 11