Filter
Top Products
17
Putting the receiver into operation
Connecting the receiver to the mains/disconnecting the
receiver from the mains
The receiver has no mains switch. To connect the receiver to the mains:
̈ Connect the supplied mains cable to the 3-pin mains socket
D.
̈ Plug the mains connector into the wall socket.
To disconnect the receiver from the mains:
̈ Pull out the mains connector from the wall socket.
All daisy chained signals are interrupted, i.e.:
– the antenna signals at the daisy chain outputs
Q and P,
– the booster supply voltage,
– the signals of the external word clock generator.
Connecting the amplifier/mixing console
The receiver has transformer balanced audio outputs.
̈ Connect the amplifier/mixing console to the XLR-3 socket
AF out 1
M (left receiver) or to the XLR-3 socket AF out 2 K (right
receiver).
̈ Via the operating menu of the corresponding receiver, adjust the level
of the audio output to the input of the amplifier or mixing console (see
“Adjusting the audio output level” on page 31).
Connecting devices with AES3 digital input
The digital balanced XLR-3M audio output G outputs the signals of both
receivers in AES3 format.
̈ Use a special double-shielded 110 Ω AES3 cable to connect the device
with AES3 digital input to the digital balanced XLR-3M audio
output
G.
This ensures that the digital data transmission interferes with the RF
reception.
Note:
A ready-made AES3 cable from Sennheiser is available as an accessory
with a length of 10 m (see “Accessories/spare parts” on page 43).
̈ Via the “Clock” menu, select the desired sampling rate (see “Selecting
the sampling rate for digitalization” on page 31).
CAUTION! Damage due to electric current!
If you connect the receiver to an unsuitable power supply, this
can cause damage to the device.
̈ Use the supplied mains cable to connect the receiver to the
mains (100 to 240 V AC, 50 or 60 Hz).
̈ Ensure a reliable mains ground connection of the receiver –
especially when you are using multi-outlet power strips or
extension cables.
EM3732_516551_0108_Sp6.book Seite 17 Dienstag, 18. Dezember 2007 11:55 11