Filter
Top Products
21
Using the receiver
Synchronizing the transmitter with the receiver frequency
Via its infra-red interface, the receiver can transfer the frequency and the
name to suitable transmitters (e.g. SK 5212, SKM 5200 or SKP 3000).
Note:
The transmitter must be from the same frequency range (“A” to “I”,
see page 5) and be equipped with the same compander system (HDP,
see page 38) as the receiver!
̈ Set the receiver to the desired receiving frequency (see “Setting the
receiving frequency” on page 28 and “Selecting a frequency bank and
a channel” on page 28) and enter the desired name (see “Entering a
name” on page 29).
̈ Press the sync button
9.
The two blue LEDs in the infra-red interface (sync)
A flash and the
backlighting of the sync button
9 flashes red. The receiver is ready for
synchronization.
̈ Position the transmitter’s infra-red interface at a max. distance of 5 cm
in front of the infra-red interface (sync)
A.
The transfer starts automatically. During the transfer, the two blue
LEDs in the infra-red interface (sync)
A flash and the backlighting of
the sync button
9 flashes green.
– After successful completion of the synchronization, the two blue
LEDs in the infra-red interface (sync)
A stop flashing and
the sync button
9 is backlit in green. The receiver’s frequency and
name are now also set on the transmitter and the transmission link
is ready for operation.
– If an error occurred during synchronization (e.g. the transmitter is
too far away from the receiver), the two blue LEDs in the infra-red
interface (sync)
A stop flashing and the sync button 9 is backlit in
red.
Note on the SKM 5200 hand-held transmitter:
The infra-red interface of the SKM 5200 hand-held transmitter is
located at the left-hand margin of the display. Position the
transmitter’s infra-red interface precisely in front of the infra-red
interface (sync)
A of the receiver.
esc
save
sync
digital audio
processing
sync
EV
M
H
z
790.800
03.03
BANK
CH
COM
AF
esc
save
sync
digital audio
processing
sync
5cm
<
300
100
30
10
1
5
1
0
PE
A
μV
RF
%
A B
SKM 5200
EM3732_516551_0108_Sp6.book Seite 21 Dienstag, 18. Dezember 2007 11:55 11