Filter
Top Products
30
The operating menu
Adjusting the squelch threshold
Squelch Both receivers are equipped with a squelch that can be adjusted via the
“Squelch” menu. The squelch eliminates annoying noise when the
transmitter is switched off. It also suppresses sudden noise when there is
no longer sufficient transmitter power received by the receiver.
The squelch can be adjusted in 13 steps from 0 to 30 μV. Selecting a
smaller value reduces the squelch threshold, selecting a higher value
increases the squelch threshold. Adjust the squelch threshold – with the
transmitter switched off – to the lowest possible value that suppresses
hissing noise.
Notes:
– If the squelch threshold is adjusted too high, the transmission range
will be reduced. Therefore, always adjust the squelch threshold to the
lowest possible setting.
– If you adjust the squelch threshold to “0”, the squelch is switched off.
If no RF signal is being received, hissing noise will occur. This setting
is for test purposes only.
To adjust the squelch threshold:
̈ Before adjusting the squelch threshold to a different setting, set the
volume on a connected amplifier to the minimum.
̈ Change to the setting mode of the “Squelch” menu.
The current setting starts flashing.
̈ Change the squelch threshold by turning the jog dial
7.
The new setting becomes effective immediately.
̈ After you have adjusted the desired squelch threshold, press the save
button
8.
The squelch threshold is stored. The display changes to the selection
mode of the operating menu.
Switching the booster supply voltage on/off
Booster If you connect antenna boosters (e.g. AB 3700) or active antennas (e.g.
A 3700, AD 3700), select “Booster Feed On” in the “Booster” menu so that
the LEDs
N and S light up; if you do not connect antenna boosters or
active antennas, select “Booster Feed Off” in the “Booster” menu so that
the LEDs
N and S do not light up.
Notes:
– The booster supply voltage is short-circuit proof.
– If you connect active antennas or antenna boosters, the current
consumption of the overall device is increased.
– If the booster supply voltage is switched on, it remains switched on
even when the receiver is switched off.
̈ Change to the setting mode of the “Booster” menu.
The current setting starts flashing.
30
30 μV
300
30
μV
10
3
esc
save
sync
digital audi
o
processing
sync
D
EV
M
H
z
790.800
03.03
BANK
CH
COM
AF
Booster Feed On
EM3732_516551_0108_Sp6.book Seite 30 Dienstag, 18. Dezember 2007 11:55 11