Filter
Top Products
28
The operating menu
Adjustment tips for the operating menu
The following adjustment tips apply to the operating menus of all
receivers of the EM 3731/3732 receiver family.
Setting the receiving frequency
Tune Via the “Tune” menu, you can:
y set the receiver to a receiving frequency that can be freely selected
within the preset frequency range. The receiving frequencies are
tunable in 5-kHz increments within the switching bandwidth of
90 MHz max. If you want to use a receiving frequency from the
enclosed frequency tables instead, see “Selecting a frequency bank and
a channel” on page 28.
y change and store the receiving frequencies in the 60 channels of the
frequency bank “U” (see page 29)
̈ Change to the setting mode of the “Tune” menu.
The first three digits of the receiving frequency start flashing.
̈ Change the first three digits of the receiving frequency by turning the
jog dial
7.
̈ Confirm the first three digits of the receiving frequency by pressing the
jog dial
7.
The last three digits of the receiving frequency start flashing.
̈ Change the last three digits of the receiving frequency by turning the
jog dial
7.
̈ After you have selected the six digits of the receiving frequency, press
the save button
8.
The selected receiving frequency is set and automatically stored on the
channel “01” of the frequency bank “U”, i.e. the previously stored
frequency is overwritten. The display changes to the selection mode of
the operating menu.
Selecting a frequency bank and a channel
B.Ch Via the “B.Ch” menu, you can select a frequency bank and a channel from
the enclosed frequency tables.
̈ Change to the setting mode of the “B.Ch” menu.
The number of the frequency bank starts flashing.
̈ Select the desired frequency bank by turning the jog dial
7.
̈ Confirm the frequency bank by pressing the jog dial
7.
The number of the channel starts flashing.
̈ Select the desired channel by turning the jog dial
7.
Note:
If during the last scan channels were detected that were occupied or
subject to interference, these channels are marked with a warning
triangle and the text “Freq. occupied” in the “Tune” menu.
̈ After you have selected the frequency bank and the channel, press
the save button
8.
790.
800
MHz
B.Ch
U.01
776
UHF MHz
866
esc
save
sync
digital audi
o
processing
sync
D
EV
M
H
z
790.800
03.03
BANK
CH
COM
AF
B.Ch
1.
790.800MHz
esc
save
sync
digital audi
o
processing
sync
D
EV
M
H
z
790.800
03.03
BANK
CH
COM
AF
B.Ch
1.
790.800 MHz
Freq. occupied
EM3732_516551_0108_Sp6.book Seite 28 Dienstag, 18. Dezember 2007 11:55 11