Filter
Top Products
27
INSTALLER
Programming Menu Instructions
4. TEST IR? – Select and enter Yes or No. Entering Yes sends the learned command to the device to test the IR. If the device
responds, the IR learning was a success. If the device does not respond, either the keypad did not properly learn the com-
mand or the command is inappropriate for the device. Entering No returns the procedure to LEARNED SRC (step 1).
5. SUCCESS? – Select and enter Yes if the IR learning was successful. The procedure returns to KEY FUNCTION (step 2) to
allow learning another command. Select and enter No if the IR learning failed. The procedure returns to LEARN/DELETE to
allow relearning the same command for the key function.
Press the Setup button to back out of the procedure.
SOURCE SETUP MENU
Note: The amp/receiver is configured for source selection and volume control under the Amp/Receiver Setup Menu on page 23.
However, if the receiver’s tuner is used as a source, it must also be configured under this menu.
The Source Setup Menu enables you to program the keypad with the IR commands needed to control the source equipment. Each
source must be IR controllable to be operated by the keypad.
The keypad’s IR device code library contains codes for most IR-controllable sources. If you don’t find a device code for a source,
you will need to use the Learn IR procedure to teach the keypad the commands from the source’s remote control.
To enter the Source Setup Menu, select SOURCE SETUP from the top level of the Programming Menu and press Play . The
Source Setup Menu offers the following procedures and features:
BASIC SETUP KEY CONFIG SOURCE NAMES NUMERIC IR SRC SEL CMD # OF SOURCES
Number of Sources Feature
This feature allows you to enter the number of sources used in the system (1 to 8). This limits the sources displayed on the keypad
when the source key is pressed in the normal running mode and also limits source selections in the programming procedures. See
Source Select Command and # Of Sources Procedures flow chart on page 50.