Filter
Top Products
26
Learn IR Procedure (continued)
These locations are called Learned Sources. Learned commands can be assigned in other procedures by selecting Learned IR as
a command type and then selecting the corresponding Learned Source label.
See Learn IR Procedure flow chart on page 45.
To begin the Learn IR Procedure, select LEARN IR from the top level of the Programming Menu and press Play .
Note: When teaching commands, you must aim the remote at the keypad’s IR
learning receiver diode. The keypad cannot learn commands through its normal
IR receiver. See the diagram at right.
1. LEARNED SRC – Select and enter the Learned Source location where you
want to store the commands. Usually the Learned Source label should
match the source number or amp/receiver to avoid confusion. To store
commands for a separate device such as a lighting system or a motorized
screen, choose any unused Learned Source location.
2. KEY FUNCTION – Select and enter a function to be learned or deleted.
3. LEARN/DELETE – Select Learn IR Now or Delete IR.
a. Select and enter Learn IR Now to teach the keypad an IR command.
A USE REMOTE prompt appears and a red LED on the keypad’s side
flashes when ready to receive the IR signal. Hold the remote control 1
to 6 inches from the keypad. Aim the remote at the IR learning receiv-
er diode on the right front edge of the keypad and quickly press and
release the key for the function you want the keypad to learn.
b. Select and enter Delete IR to delete any existing command for that
function. Procedure returns to LEARNED SRC (step 1).
INSTALLER
Programming Menu Instructions
IR learning
receiver diode
Normal IR
receiver