Filter
Top Products
Operation
Runco LS-10i Installation/Operation Manual 43
PRE
L
IMINAR
Y
4.1
Selecting An Input
Source
When you turn on the LS-10i, it switches to the last selected input and looks for a valid
signal.
Use these buttons on the remote control to select an
input source directly.
You can assign the HD 1, HD 2 and HD 3 buttons to any
input, or to the Picture-in-Picture (PIP) function. The
default assignments are: HD 1 = Component 1,
HD 2 = Component 2, HD 3 = RGB.
For more information, refer to HD 1 Key / HD 2 Key / HD 3 Key on page 66.
4.2
Selecting An Aspect
Ratio
Use these buttons to select the appropriate aspect ratio
for the type of program material being viewed. Refer to
Table 4-2 for more information.
4.3
Selecting Video
Memory
Press CUST1, ISF NIGHT, ISF DAY or CUST2 to recall
settings from a memory preset. Then, press ENTER to
confirm your selection. Or, to cancel the operation, press
to select Cancel and press ENTER.
4. Operation
VID S-VID HDMI 1
HD 2
SOURCE
HD 1 HD 3
HDMI 2
ASPECT RATIO
16:9
VWIDELBOX
4:3
CINEMA
VCINE
2
1
PICTURE MEMORY
ASPECT RATIO
CUST1
ISF
NIGHT
ISF
DAY
CUST2