Filter
Top Products
Controls and Functions
Runco LS-10i Installation/Operation Manual 9
PRE
L
IMINAR
Y
9. TRIGGER 2 (3.5-mm, mini phono jack)
Provides 12 (+/- 1.5) volt switched output for an anamorphic lens transport (if
installed) or screen relays with 250mA current capacity and short protection.
10. TRIGGER 1
Provides 12 (+/- 1.5) volt switched output for an anamorphic lens transport (if
installed) or screen relays with 250mA current capacity and short protection.
11. RS-232
A female, 9-pin D-sub connector for interfacing with a PC or home theater
automation/control system.
2.3
LS-10i Remote Control
1. LIGHT
Press to illuminate the
buttons.
2. ON / OFF
Use these buttons to
turn the projector on or
off.
3. Source Selection
Buttons:
VID
Press to select
Composite video input
as the source.
S-VID (S-Video)
Press to select the
S-Video input as the
source.
HDMI 1 / HDMI 2
Press to select an HDMI
input.
HD 1 / HD 2 / HD 3
Press to select the
“HD 1,” “HD 2” or “HD 3”
video input as the
source. By default, these
buttons are assigned to
the COMPONENT 1,
COMPONENT 2 and RGB video inputs respectively; however, you can re-assign
these buttons to other inputs.
You can also assign these buttons to the Picture-in-Picture (PIP) function. For more
information, refer to HD 1 Key / HD 2 Key / HD 3 Key on page 66.
FOCUS LENSZOOM
LIGHT
OFF
ON
VID S-VID HDMI 1
HD 2
SOURCE
PICTURE MEMORY
ASPECT RATIO
HD 1
INFO
ENTER
EXIT MENU
BRT
CUST1
ISF
NIGHT
ISF
DAY
CUST2
CONT COL TINT
HD 3
HDMI 2
16:9
VWIDELBOX
4:3
CINEMA
VCINE
FOCUS
ZOOM
2
1
5
46
3
9
80
7
LENS
6
1
5
2
4
3
8
7
9