Filter
Top Products
Installation
Runco LS-10i Installation/Operation Manual 15
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the LS-10i installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer
to page...
1
Choose a location for the projector 16
2
Install anamorphic lens mounting assembly (optional) 21
3
Mount the projector 27
4
Connect signal sources to the LS-10i 30
5
Connect external controller to RS-232 port and/or IR repeater
system (optional)
35
6
Connect 12-volt trigger output to retractable screen or other,
+12V trigger-activated equipment (optional)
36
7
Apply power to the projector 37
8
Primary lens adjustments: projected image size (zoom), position
(shift) and focus
19, 38
9
Change the OSD Language (optional) 39
10
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation
39
11
Install and adjust secondary anamorphic lens (optional) 40
12
Projector calibration: adjust the following for each input; save
settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
46
Note