Filter
Top Products
Installation
40 Runco LS-10i Installation/Operation Manual
PRE
L
IMINAR
Y
3.11
Installing and
Adjusting the
Anamorphic Lens
If you are installing an LS-10i with an anamorphic lens, proceed as follows to install and
adjust the lens.
Anamorphic Lens
Installation and
Adjustment
Attach the anamorphic lens to the bracket using the plastic knobs supplied with the lens.
See Figure 3-16.
Figure 3-16. Attaching the Anamorphic Lens to the Lens Mount
Configure Lens Motor Trigger: The anamorphic lens solution for the LS-10i maintains
constant image height independent of the aspect ratio, while using the full display
resolution of the projector. It accomplishes this by moving the anamorphic lens in front of
the primary lens when widescreen material is being viewed. When the viewer transitions
back to 16:9 or 4:3 source material, the anamorphic lens moves out of the light path.
Proceed as follows to confirm that the +12V trigger output to which the lens transport is
connected is configured for proper operation.
1. Project a 2.35:1 aspect ratio test pattern or other image on the screen.
2. Press MENU on the remote control.
3. Press or to select Control from the Main Menu.
4. If the +12V trigger output to which the lens transport is connected is set to
AutoScope, skip to Step 7. Otherwise, continue with Step 5.
5. Press or to highlight Trigger 1 or Trigger 2.
6. Press or to select AutoScope.
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Note
➤
You can skip this step if you connected the lens transport motor to
the TRIGGER 2 output on the LS-10i, as shown in Figure 3-14.
Note