2,
Aim the speakersdirectly at the two main
speakers,matching height to height. If the room is
sparselydecorated, it may be necessaryto slightly
tilt the speakersdown to increase sound
quality. If the room isdensely decorated, it may be
necessary to face the speakers toward the rear
wall or at the ceiling.
3. Mount the speakersup on the ceiling. Setthem a
few feet wide of the listeners and make surethey
are facing one another, not the floor.
Obviously there are many more possible positions, so it
may be necessary to simply experiment to find the
right balance for your situation.
SUBWOOFER
Before you begin, make sure that the subwoofer is
turned off and unplugged.
Connect your AN receiver to the subwoofer asshown.
NOTE: A receiver with a single output should be
connected to the input labeled LOW-LEVEL INPUT.
BALANCING YOUR SPEAKERS
Yoursystemis equipped with ITI_=_., which
enables you to reproduce soundeffects as they were
intended. But to do so, the speakersmust be correctly
balanced.
To balance the speakersusingthe TestTone, all
speakersmust be connected to your receiver. Your
receiver must be in the Dolby Pro Logic Surround
Mode.
1. Pressthe TESTTONE button on the receiver front
panel. The receiver generates a "pink noise" and
applies it automatically at two-second intervals to
the left main channel, center channel right main
channel and left and right rear channels
(simultaneously), in that order.
2,
Asthe pink noise isgenerated, go to the spot in
the room where you are most likely to be when
listening to your system.The rear surround and
center speakersshould be adjusted to equal the
level of output from the left and right main
speakers.
3,
Make adjustments by pressing the REAR-CTR
button, and then the +1-button on your remote
control. The output from the selected speaker(s) is
adjusted accordingly.
SIJBWOO_I_R
A SAMPLE SET UP FOR SURROUND
SOUND ENJOYMENT
J
* fln_ Manufactured under license from Oolby Laboratories Licensing Corporation. Oolby. the double-D symbol (1_) and
" Pro Logic" are trademarks of Dolby Laboratories Licensing Corporation.
6