Filter
Top Products
C
MENU SELECT Programsthe CD changer to play up
to 32 tracks in any order you choose.
Number Buttons Let you enter numbers when
needed.
PAUSE Pauses the CD.
PLAY Playsthe CD.
RESET.REP Repeats atrack, a CD or an entire
program. Pressonce to repeat the currently playing
track, twice for the CDor program, and three times to
turn the function off.
REV Moves backward through the CD one track at a
time.
STOP Stopsthe CD from playing.
TAPE DECK CONTROLS
FWD Fastforwards the tape.
Number Buttons Let youenter numberswhen
needed.
PAUSE Pausesthe tape.
PLAY Playsthe tape.
POWER Turnsthe tape player off.
REV Rewindsthe tape.
TAPE Turnson the tape player and putsthe remote in
tape player mode.
LASERDISC PLAYER CONTROLS
CH + and CH - Changes to the next higher or lower
chapter on the laserdisc.
FWD Scans forward on the laserdisc.
LD.VCR2 For some laserdisc models, if programmed,
turns on the laserdisc player and puts the remote in
laserdisc mode.
Number Buttons Let you changeto a specific
chapter.
PAUSE Pauses the laserdisc.
PLAY Playsthe laserdisc.
PLAYLIST Forsome laserdisc models, if programmed,
programsto playbackchapters on laserdiscin a certain
order.
POWER Turnsthe laserdiscplayer off.
REV Scansbackward on the laserdisc.
STOP Stops the laserdisc.
PROGRAMMING THE
UN IVERSAL REMOTE
You can program the remote to control most brands of
remote controllable TVs, VCRs and cable boxes. If you
have an RCA, GE or ProScan VCR, you may not need to
program the remote at all. Other manufacturer's
brands need to be programmed.
PROGRAMMING THE REMOTE
TO CONTROL A TV
To determine whether you need to program the
remote, turn onthe TV, point the remote at the TV's
remote sensor and pressTV. Then, press the POWER,or
CH + or CH - button to see if the TV responds to the
remote commands. If not, you need to program the
remote.
Follow these stepsto program your remote to control
your TV:
1. Turn on the TV.
2. Lookup your TV brand and code number(s) in the
code list on the next page or on the codesheet
packed with your remote.
3.
4.
5.
6.
Pressand hold the TV button on the remote.
Enter the three-digit code from the code list.
Releasethe TV button, then pressPOWERto see if
the TV responds to the remote commands.If not,
try pressing TV
then POWER.
Repeat steps3 through 5 using the next code listed
for your TV brand until the TV responds to the
remote commands.
I If youhave questions about the useof the remote |
buttons with another component, refer to the
J
components user sguide.
19 ¸