PROGRAMMI NG THE REMOTE
TO CONTROL A DVD PLAYER
The remote is preprogrammed to control a RCA DVD
player. A few of the remote buttons used with a DVD
player are shown below. You may want to experiment
with other buttons on the remote to see if they work
with your DVD player.
Receiver Remote (works like) DVD Remote
INFO INFO
GO BACK GO BACK
CLEAR CLEAR
MENU SELECT MENU SELECT
MOVE Arrows ARROWS
PLAYLIST PLAYLIST
ENTER ENTER
PROGRAMMING THE REMOTE
TO CONTROL AN RCA BRAND DSS®
RECEIVER
The remote ispreprogrammed to control the RCA
brand DSSereceiver. A few of the remote buttons used
with the RCA brand DSS° receiver are shownbelow.
You may want to experiment with other buttons on
the remote to see if they work with your receiver.
Receiver Remote (works like) RCA brand DSSe
Remote
INFO SELECT/DISPLAY
GO BACK PREV CH
ANTENNA TV/SAT
CLEAR CLEAR
MENU/SELECT MENU
MOVE ARROWS ARROWS
PROGRAMMING THE REMOTE
TO CONTROL A SATELLITE RECEIVER
1. Turn on the satellite receiver.
2. Look up the satellite receiver brand and
corresponding code number(s) in the codelist on
the right.
3. Pressand hold the SAT.CABLEbutton on
the remote.
4. Enter the three-digit code from the codelist.
5. Release the SAT-CABLEbutton, then press POWER
or CH + or CH - to see if the receiver responds to
the remote's commands. If it doesn't, try pressing
SAT.CABLE,then POWERagain.
6. Repeat steps 3through 5 using the next code listed
for the brand of your receiver until the receiver
responds to the remote commands.
fr
Thisremote may not operate all models of the
brands shown.
If a battery is removed from the battery
compartment of the remote control, all control key
functions will return to the original mode.
To program the LD-VCR2 button to control a second
VCR, follow these steps but use the LD-VCR2 button
instead of the VCR button.
The buttons on the remote may not work on all
other brands of components. Experiment with the
remote and your components to see which buttons
work.
DSS"isa registered trademark of DIRECTV,INC., a unit of GM HughesElectronics.
21