Filter
Top Products
10
CONNECTING THE SPEAKERS
The speaker cords have been color-coded to simplify connection.
1. Plug the POSITIVE (+) and NEGATIVE (-) ends of each speaker
wire into the corresponding jacks on the rear of the receiver,
matching the color tube on the end of the speaker wire to the
color-coded connector.
2. Connect each of the speaker wires to the satellite speakers. The
front left/right and rear left/right speakers are all the same. Make
sure to connect the center speaker, which is a little larger than
the rest.
3. Use the supplied RCA cable to connect the
SUBWOOFER OUT
jack on the back of the unit to the SUBWOOFER IN jack on the
back of the active subwoofer.
Speaker Positioning
Mounting Rear Surround Speakers
1. Mark the correct mounting position on the wall.
2. Insert a fixing screw(s) at the marked position on the wall.
3. Align the slot hole(s) of the speaker over the screw and pull the
speaker downward until it is firmly hooked.
POWER CORD CONNECTION
1. Make sure that all the components and speakers are connected
correctly.
2. To prevent electrical shock, match wide blade of the plug to
wide slot on the outlet, and fully insert.
3. Be sure the AC power cord is disconnected and all functions are
off before making connections.
4. When you are not going to use the unit for a long period of time,
disconnect the power cord.
Center Channel Speaker
Subwoofer
HTIB
Receiver
Rear Satellite
Speaker
Rear Satellite
Speaker
Front Channel
Speaker
Front Channel
Speaker