Filter
Top Products
Additional information
10
66
En
Broadcast stations cannot be
selected automatically.
• Connect an outdoor antenna (refer to page 20).
No sound from surround or
center speakers.
• Refer to Speaker setting on page 45 to check the speaker settings.
• Refer to Manually calibrating your listening area (MCACC) on
page 51 to check the speaker levels.
• Connect the speakers properly (refer to page 21 or page 22).
No sound from surround
back speakers.
• Refer to Surround back speaker setting on page 46 to check the sur-
round back speaker settings.
• Refer to Using the Surround Back Channel (SB CH) on page 40 to
make sure the SB CH MODE and the sound mode are set for sur-
round back sound.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• Switch the Subwoofer setting on page 46 to YES or PLUS.
• Switch the LFE attenuator setting on page 47 to 0 dB or 10 dB.
• The Dolby Digital or DTS source you are listening to does not have
an LFE channel.
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
Sound is produced from
other components, but not
from LD or DVD player.
• Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG accord-
ing to the type of connections made. (refer to page 37).
• Set the digital input settings correctly (refer to page 50).
• Make digital connections (refer to page 16) and set the SIGNAL
SELECT to DIGITAL (refer to page 37).
• Refer to the instruction manual supplied with the DVD player.
No sound is output or a noise
is output when software with
DTS is played back.
• Set the digital volume level of the player to full, or to the neutral
position.
When a search is performed
by a DTS compatible CD
player during playback, noise
is output.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Can’t operate the remote
control.
• Replace the batteries (refer to page 6).
• Operate within 23 feet ( 7 m), 30° of the remote sensor on the front
panel (refer to page 7).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off. • Press FL DIMMER on the remote control repeatedly to return to
the default.
Problem Remedy