Pioneer VSX-D712 Stereo Receiver User Manual


 
Connecting up
03
27
En
If you’re not using a subwoofer, change
the front speaker setting (see Speaker
setting on page 45) to large.
VSX-D712 only – If you connect to a
surround back speaker, make sure the
Surround back speaker setting on page 46
is switched on and set to the proper
speaker size.
AC outlet
Power supplied through this outlet is turned
on and off by the receiver's power switch.
Total electrical power consumption of
connected equipment should not exceed 100
W (0.8 A).
Do not connect a monitor, TV set, heater,
or similar appliance to this unit’s AC
outlet.
Do not connect appliances with high
power consumption to the AC outlet in
order to avoid overheating and fire risk.
This can also cause the receiver to
malfunction.
Make sure no exposed speaker wire is
touching the rear panel, this may cause
the receiver to turn off automatically.
This unit should be disconnected by
removing the power plug from the wall
socket when not in regular use (ex. when
on vacation).
Power cord caution
Handle the power cord by the plug. Do not
pull out the plug by tugging the cord and
never touch the power cord when your hands
are wet as this could cause a short circuit or
an electric shock. Do not place the unit, a
piece of furniture, etc., on the power cord, or
pinch the cord. Never make a knot in the cord
or tie it with other cords. The power cords
should be routed such that they are not likely
to be stepped on. A damaged power cord can
cause a fire or give you an electrical shock.
Check the power cord once in a while. When
you find it damaged, ask your nearest Pioneer
authorized service center or your dealer for a
replacement.
AC OUTLET
SWITCHED
100 W MAX
0.8 A MAX