Filter
Top Products
5 minute guide
02
13
En
Using the Quick Setup
You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position. If you want to make more specific
settings, refer to Choosing your receiver setup
on page 44.
Use the front panel controls for the steps
below.
1 If the receiver is off, press
STANDBY/ON to turn the power on.
The
STANDBY
indicator goes out.
2 Press QUICK SETUP.
SW DET
flashes in the display while the
receiver checks your setup for a subwoofer.
SW YES
or
SW NO
confirms the subwoofer
check, then the display prompts you to select
your speaker setup.
3 Use the MULTI JOG dial to choose your
speaker setup.
When a subwoofer was detected in step 2, you
can cycle between the following choices:
*
VSX-D812 only
If a subwoofer wasn’t detected in step 2, you
can cycle between the following choices:
*
VSX-D812 only
• Check the table below to find the speaker
setup that corresponds with your system.
*
VSX-D812 only
4 Press ENTER.
5 Use the MULTI JOG dial to choose your
room size.
Depending on the distance of your speakers
from the listening position, choose between
small, medium, or large (
S
,
M
or
L
),
M
being
an average-sized room.
6 Press ENTER.
DOWN UP
MULTI JOG
MASTER VOLUME
ENTER
SPEAKERS
S-VIDEO VIDEO L AUDIO R
ADVANCED
SURROUND
STEREO/
DIRECT
SIGNAL
SELECT
MIDNIGHT/
LOUDNESS
SB CH
MODE
L
ISTENING MODE
TONE
QUICK
SETUP
VIDEO INPUT
PHONES SURR.
FL DIMMER
MULTI JOG
7.1ch*
4.1ch
6.1ch 5.1ch
2.1ch 3.1ch
7.0ch*
4.0ch
6.0ch 5.0ch
2.0ch 3.0ch