Filter
Top Products
Controlling the rest of your system
09
59
En
If the correct code has been input the power
of the component being input will turn on or
off.
The power of the component being input will
only turn on or off if that component is able to
be turned on directly by remote control.
• You can only input a code for the compo-
nent type written on each MULTI
CONTROL button (except RECEIVER and
TUNER).
• Even if you don’t input a preset code for
the TV (TV/SAT MULTI CONTROL button)
you will be able to control your TV using
the dedicated TV CONTROL on the
remote if you have assigned it to the TV
CONT button.
• You may not be able to use a particular
code even if it is listed on page 63.
• The remote control buttons will not be
able operate other equipment unless
preset with the method above.
4 Repeat steps 2 through 3 to try a
different code, or to enter a code for
another component you want to control.
5 When you’re done, press RECEIVER.
Clearing all the remote
control settings
You can clear all presets and restore the
factory default settings.
• While pressing the RECEIVER button,
press and hold the 0 button for three
seconds.
The LED blinks three times indicating the
settings have been restored to the factory
presets.
Direct function
• Default setting: ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the
remote control to set up and listen to a CD on
the receiver and then use the remote control
to rewind a tape in your VCR while you
continue to listen to your CD player.
When direct function is on, any component
you select (using the MULTI CONTROL
buttons ) will be selected by both the receiver
and the remote control. When you turn direct
function off, you can operate the remote
control without affecting the receiver.
1 While pressing the RECEIVER button,
press and hold the 4 button.
The LED blinks.
2 Press the MULTI CONTROL button for
the component you want to control.
The LED lights.
3 Use the number buttons to enter
either 1 (direct on) or 2 (direct off).
The LED blinks again.
4 Repeat steps 2 through 3 for the other
components you want to control.
5 When you’re done, press RECEIVER.
• You can’t use direct function for TUNER.