Filter
Top Products
Connecting up
03
15
En
Chapter 3:
Connecting up
• Before making or changing any connec-
tions, switch off the power and discon-
nect the power cord from the AC outlet.
Audio/Video cords
Use audio/video cords (not supplied) to
connect the audio/video components and a
video cord to connect the monitor TV.
Connect red plugs to R (right), white plugs to
L (left), and the yellow plugs to VIDEO.
Be sure to insert completely.
S-video cables
Use S-video cables (not supplied) to get
clearer picture reproduction than regular
video cords.
Connect from an S-video jack on the rear of
the receiver to an S-video jack on the video
component you are hooking up.
Be sure to insert completely.
Component video cords
Use component video cords to get the best
possible color reproduction of your video
source. The color signal of the TV is divided
into the luminance (Y) signal and the color
(PB and PR) signals and then output. In this
way, interference between the signals is
avoided. Connect from the component video
jacks on the rear of the receiver to the compo-
nent video jacks on the video component you
are hooking up.
Digital audio coaxial cords/
Optical cables
Commercially available digital audio coaxial
cords (standard video cords can also be used)
or optical cables (not supplied) are used to
connect digital components to this receiver.
Be sure to insert completely.
L
R
VIDEO
S VIDEO
Y
P
B
P
R
Green
Blue
Red
Digital audio coaxial cord
(or standard video cord)
Optical cable