Filter
Top Products
Using the tuner
07
56
En
4 Press ENTER.
After pressing
ENTER
, the preset class and
number stop blinking and the receiver stores
the station.
Naming station presets
For easier identification, you can name your
station presets.
1 Choose the station preset you want to
name.
See
Listening to station presets
below for how
to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows
ST. NAME
, then a blinking
cursor at the first character position.
3 Input the name you want.
Names can be up to four characters long.
• Use the
MULTI JOG
dial (front panel) or
the
ST +/–
buttons (remote) to select
characters.
• Press
ENTER
to confirm a character. If no
character is input, a space is input.
• The name is stored when
ENTER
is
pressed after choosing the fourth char-
acter.
• To erase a station name, simply repeat
steps 1-3 and input four spaces instead of
a name.
• Once you have named a station preset,
you can press
DISPLAY
when listening to
a station to switch the display between
the name and the frequency.
Listening to station presets
You will need to have some presets stored to
do this. See
Saving station presets
on page 55
if you haven’t done this already.
1 Press TUNER to select the tuner.
2 Press CLASS to select the class in which
the station is stored.
Press repeatedly to cycle through classes A,
B and C.
3 Press ST +/– (STATION +/–) to select
the station preset you want.
• If the receiver is left disconnected from
the AC power outlet for an extended
period, the station memories will be lost
and will have to be reprogrammed.