Filter
Top Products
Setting up the receiver
06
46
En
One of the following configurations should
match your setup:
Surround back speaker setting
• Default setting: S (VSX-D812), (VSX-
D712)
You must let the receiver know if surround
back speaker(s) have been connected, and
how big they are. The size you choose (large or
small) determines how much bass is sent
from the receiver to the speakers. If you have
connected a surround back subwoofer (VSX-
D812), you should select the surround back
subwoofer setting (SB SW) from the options.
Choose (asterisk) if no speaker is
connected.
• Use or to select SB S, SB , SB SW
or SB L.
* VSX-D812 only
• To select SB L, you must have SL selected
in the Speaker setting.
Subwoofer setting
You can choose whether the subwoofer is
used or not. Use the plus (PLUS) setting for
extra bass.
• Use or to select subwoofer YES,
PLUS or NO.
• If you chose the small front speaker
setting, SW YES is automatically set and
locked.
• When you select the PLUS setting, you
will get the bass sounds from the
subwoofer even if the front speakers are
set to L.
Crossover frequency setting
• Default setting: 100 Hz
Crossover frequency is the point where the
receiver divides the high and low sounds (the
frequencies) between the speakers. Since
most smaller speakers can’t handle deep
bass tones, you can send these sounds to the
subwoofer (or if you don’t have a subwoofer,
the large (L) speakers in your system) instead
of the speakers set to small (S) in your setup.
Choose the point at which you want the
frequency routed to the subwoofer (or L
speakers).
FL-CL-SL
FL-CL-SS
FL-CL-S
FL-CS-SL
FL-CS-SS
FS-C -SS
FS-CS-S
FS-CS-SS
FL-C -SS
FL-C -SL
FL-CS-S
FL-C -S
FS-C -S
SB S SB
SB SW*
SB L
YES PLUS
NO