Filter
Top Products
Playing sources
05
43
En
4 Start playback of the component you
selected in step 1.
Selecting the multi-channel
analog inputs
If you have connected a decoder or a DVD
player with multi-channel analog outputs to
this receiver (page 18), you must select the
analog multi-channel inputs for surround
sound playback.
1 Press DVD/LD.
2 Press SIGNAL SELECT repeatedly to
select DVD 5.1ch/DVD 7.1ch.
To cancel playback from the multi-channel
inputs, use the SIGNAL SELECT button to
select a different input signal.
• When playback from the multi-channel
inputs is selected, you can’t use the
INPUT ATT, TONE, and MIDNIGHT/
LOUDNESS buttons, as well as the STAN-
DARD, ADVANCED SURROUND, and
STEREO/DIRECT sound modes.
• When playback from the multi-channel
inputs is selected, only the volume and
channel levels can be set.
Using the sleep timer
The sleep timer switches the receiver into
standby after a specified amount of time so
you can fall asleep without worrying about the
receiver being left on all night. Use the remote
control to set the sleep timer.
1 Press RECEIVER.
2 Press SLEEP repeatedly to set the sleep
time.
• You can check the remaning sleep time at
any time by pressing SLEEP once.
Pressing repeatedly will cycle through the
sleep options again.
• You can also switch off the sleep timer
simply by switching off the receiver.
STANDBY
STANDBY/ON
PHONES
PULL OPEN
DVD/LD TV/SAT VCR/DVR VIDEO
CD
CD-R/
TAPE/MD
TUNER
AUX
STATION
STANDARD
ADVANCED
SURROUND
STEREO/
DIRECT
TUNING
LISTENING MODE
TUNER EDIT
CLASS
BAND
MPX
MULTI JOG
PHONES SURR.
INPUT ATT FL DIMMER
STANDARD SPEAKERS
S-VIDEO VIDEO L AUDIO R
ADVANCED
SURROUND
STEREO/
DIRECT
SIGNAL
SELECT
MIDNIGHT/
LOUDNESS
SB CH
MODE
LISTENING MODE
TONE
QUICK
SETUP
VIDEO INPUT
PHONES SURR.
INPUT ATT FL DIMMER
MULTI JOG
Off
90 min 60 min
30 min