Filter
Top Products
Listening to your system
05
41
En
Neo:6 Music settings
• Default setting:
2
When listening to 2-channel sources in Neo:6 Music
mode, you can adjust the center image to create a wider
stereo effect with vocals. Note that this is only available
when using a center speaker.
1 Press RECEIVER.
2 With NEO:6 MUSIC mode active, press EFFECT/CH
SEL repeatedly to select CENTER IMAGE.
3 Use the +/– buttons to adjust the setting.
Adjust the effect from
0
(no effect) to
5
(most prominence
given to the center channel).
Adjusting the advanced effect level
• Default setting:
50
(except
5/7CH STEREO
:
90
)
You can emphasize or reduce the level of the advanced
effects as you like. You can set the effect level
independently for each mode.
1 Press RECEIVER.
2 With one of the advanced effect modes active,
press EFFECT/CH SEL repeatedly until EFFECT shows
in the front panel display.
3 Use the +/– buttons to adjust the effect level.
The effect level can be adjusted from
10
(min) to
90
(max).
Listening in stereo
When you select
STEREO
or
DIRECT
, you will hear the
source through just the front left and right speakers (and
possibly your subwoofer depending on your speaker
settings). Dolby Digital and DTS multichannel sources
are downmixed to stereo.
• While listening to a source, press STEREO/DIRECT
for stereo playback.
Press repeatedly to switch between:
•
STEREO
– The audio is heard with your surround
settings (such as channel level) and you can still use
digital processing (such as the Midnight, Loudness,
and Tone control functions).
•
DIRECT
– Bypass all effects and surround settings so
that the audio remains as close to the source audio
signal as possible.
Note
• If you switch on any signal processing features (for
example, digital noise reduction or the tone controls)
when
DIRECT
is selected, the receiver automatically
switches to
STEREO
.
Listening with headphones
When headphones are connected, all multichannel
sources, as well as all of the
MOVIE
and
MUSIC
modes
with be downmixed to 2 channels. Two channel sources
will be heard in stereo.
• Connect a pair of headphones to the PHONES
jack on the front panel.
All sources will be heard in stereo (downmixed). When
you disconnect them it reverts to the previous mode.
Note
• Many receiver features (such as matrix decoding) are
not accessible when the headphones are connected.
• When headphones are connected, no sound is heard
from the speakers. However, sound will still be output
from the preouts.
• You can only hear the front left and right channels
when
MULTI CH IN
is switched on.
+
EFFECT/CH SEL
RECEIVER
+
EFFECT/CH SEL
RECEIVER
STEREO/
DIRECT
VSX-AX5Ai.book 41 ページ ２００４年６月２日 水曜日 午後３時２７分