Filter
Top Products
Using other functions
11
56
En
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
• Press
RECEIVER
then press DIMMER repeatedly to
change the brightness of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6 Ω impedance rating. Use
the front panel controls to do this.
• With the receiver in standby, press
STANDBY/
ON
while holding down the
SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω.
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel
TONE
button,
press and hold
STANDBY/ON for about three
seconds.
The display shows RESET?.
3 Press the front panel
ENTER
button.
The display shows RESET OK?.
4 Press
SYSTEM SETUP
to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
CD
RECEIVER
TUNERiPod
USB
CD-R/TAPE
ANALOG
AT T
MIDNIGHT/
LOUDNESS
DIMMER
SLEEP SB ch
SR+
DIALOG E PHASE
S.RETRIEVER
VSX-1017_HY.book Page 56 Tuesday, March 6, 2007 3:53 PM