Filter
Top Products
64
Remote Control of Other Components
Programming Signals from Other Remote Controls (LEARNING Mode)
If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this procedure to program in signals from the remote control(s) of your other component(s). These
steps can also be used to add further operations to the remote control that were successfully set with the
stored settings (see p.62-63).
1
Press the REMOTE SETUP button for
three seconds.
The REMOTE SETUP menu appears on the remote
display.
2
Use the 5∞ buttons to select
LEARNING and press ENTER.
SELECT FUNCTION blinks on the remote control.
3
Press the MULTI CONTROL button
for the component you want to
control.
For example DVD/LD
SELECT KEY flashes in the display.
4
Choose the command you want to
teach the remote control and press
the corresponding button. The word
LEARN will blink in the remote
control display.
For example, choose the 3 (play) button to program
this remote control to play your DVD player.
• The TV POWER, TV FUNC, TV CH +/– and VOL +/–
buttons are only available for learning when
programming TV CONT button.
memo
OFF
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
AXD7290
S0URCE
Î
TV
MULTI CONTROL
SYSTEM RECEIVER
DVD/LD
TV SAT
TV CONT
VCR1/
DVR
VCR2 VIDEO
MULTI
OPERATION
CD
DIMMER
CD-R/
TAPE1
TUNER
RECEIVER
1
INPUT ATT
2
LOUDNESS
3
SPEAKER A/B
4
VIDEO SEL
5
SIGNAL SEL
6
TAPE 2
DIRECT ACCESS DISP MODE
– +
+
10 DISC
ENTER
7
EFFECT/CH SELL
8
TONE
9
BASS/TREBLE
0
SYSTEM SETUP
TUNER EDIT
MENU
REMOTE SETUP
STATUS
MPX
GUIDE
EXIT
RETURN
ENTER
¶
TUNING
–
STATION
SURROUND
LISTENING
MODE
–
CHANNEL
–
1
4
DTV ON/OFF
TUNING
+
+
CHANNEL
+
¡
STATION
¢
8
3
7
EXTRA MENU
BAND
DTV MENU CLASS
TV INPUT
TV CONTROL
TV CH
TV VOL VOLUME
INPUT
MIDNIGHT
DIGITAL
NR
STEREO
/DIRECT
THX MUTE
STANDARD
LISTENING
CH SELECT
MULTI CH
INPUT
ACOUSTIC
CAL
ADVANCED
CONCERT
ADVANCED
CINEMA
(DVD-A/SACD)
LIGHT
SETUP
3
2
1
• To exit from the remote control setup mode at any time, press REMOTE SETUP.
• You can also program the 5˜∞˜2˜3 and ENTER buttons with the LEARNING mode.
• The TUNER button cannot be assigned.
• The display will disappear after one minute or so if no new commands are entered. Press any button
to 'wake up' the remote and continue the process.