Filter
Top Products
111
Techno Tidbits & Problem-solving
EXPERT
Specifications
Maintenance of External Surfaces
• Use a polishing cloth or dry cloth to wipe off dust
and dirt.
• When the surfaces are dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted five
or six times with water, and wrung out well, and
then wipe again with a dry cloth. Do not use
furniture wax or cleaners.
• Never use thinners, benzine, insecticide sprays
or other chemicals on or near this unit, since
these will corrode the surfaces.
Amplifier Section
Continuous average power output of
160 watts* per channel, min., at 6
ohms, from 20 Hz to 20,000 Hz with no
more than 0.09 %** total harmonic
distortion (front).
Continuous Power Output (6 Ω)
Front ....... 160 W + 160 W (20 Hz-20 kHz, 0.09 %, 6 Ω)
Center ................... 160 W (20 Hz-20 kHz, 0.09 %, 6 Ω)
Surround.....160 W + 160 W (20 Hz-20 kHz, 0.09 %, 6 Ω)
Surr. back....160 W + 160 W (20 Hz-20 kHz, 0.09 %, 6 Ω)
Continuous Power Output ( 8 Ω)
Front ....... 130 W + 130 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Center ................... 130 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Surround ...........130 W + 130 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Surr. back ..........130 W + 130 W (20 Hz-20 kHz, 0.09 %, 8 Ω)
Audio Section
Input (Sensitivity/Impedance)
PHONO MM.........................................4.7 mV/47 kΩ
LINE.....................................................382 mV/47 kΩ
Phono Overload level (T.H.D.0.1 %, 1kHz)
PHONO MM ..................................................... 120 mV
Frequency Response
PHONO MM .................... 20 Hz to 20,000 Hz ± 0.3 dB
LINE .......................................5 Hz to 100,000 Hz dB
Output (Level/Impedance)
LINE ...................................................... 382 mV/2.2 kΩ
Tone Control
BASS .....................................................± 6 dB (100 Hz)
TREBLE .................................................± 6 dB (10 kHz)
LOUDNESS ........................... +4/+2 dB (100Hz/10 kHz)
(at volume position -40dB)
Signal-to-Noise Ratio (IHF, short circuited, A network)
PHONO MM ........................................................ 86 dB
LINE ................................................................... 105 dB
Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]
PHONO MM ........................................................ 83 dB
LINE ..................................................................... 93 dB
* Measured pursuant to the Federal Trade Commission’s
Trade Regulation rule on Power Output Claims for
Amplifiers.
** Measured by Audio Spectrum Analyzer.
Video Section
Input (Sensitivity) ..........................................1 Vp-p/75 Ω
Output (Level/Impedance) ............................1 Vp-p/75 Ω
Signal-to-Noise Ratio .............................................. 70 dB
Frequency Response ..................... 5 Hz to 10 MHz dB
Component Video Section
Input (Sensitivity) ..........................................1 Vp-p/75 Ω
Output (Level/Impedance) ............................1 Vp-p/75 Ω
Signal-to-Noise Ratio .............................................. 70 dB
Frequency Response ..................... 5 Hz to 40 MHz dB
FM Tuner Section
Frequency Range ........................... 87.5 MHz to 108 MHz
Usable Sensitivity........ Mono: 13.2 dBf, IHF (1.3 µV/75 Ω)
50 dB Quieting Sensitivity.........................Mono: 20.2 dBf
Stereo: 38.6 dBf
Signal-to-Noise Ratio ................... Mono: 73 dB (at 85 dBf)
Stereo: 70 dB (at 85 dBf)
Distortion ........................................ Stereo: 0.5 % (1 kHz)
Alternate Channel Selectivity ................... 60 dB (400 kHz)
Stereo Separation ........................................ 40 dB (1 kHz)
Frequency Response ................. 30 Hz to 15 kHz (± 1) dB
Antenna Input .........................................75 Ω unbalanced
AM Tuner Section
Frequency Range ............................ 530 kHz to 1,700 kHz
Sensitivity (IHF, Loop antenna)........................... 350 µV/m
Selectivity................................................................. 25 dB
Signal-to-Noise Ratio ................................................ 50 dB
Antenna........................................................Loop antenna
Miscellaneous
Power Requirements ...............................AC 120 V, 60 Hz
Power Consumption ...............................................710 W
Power Consumption in Standby mode .................. 0.65 W
AC Outlet
SWITCHED......................................100 W (0.8 A) MAX
Dimensions .................... 440 (W) × 203 (H) × 472 (D) mm
(17-
5
/16 (W) × 8 (H) × 18-
9
/16 (D) in.)
Weight (without package) ................... 28.3 kg (62 lb 4 oz)
Furnished Parts
FM wire Antenna .............................................................1
AM Loop Antenna ........................................................... 1
“AA” IEC LR6 batteries .................................................. 4
Remote Control Unit ........................................................1
Remote Control Cable .................................................... 1
Remote Control Stand .................................................... 1
U-shaped connectors .......................................................2
AC Power Cord ............................................................... 1
Operating Instructions .................................................... 1
NOTE:
Specifications and the design are subject to possible
modifications without notice, due to improvements.
+0
–3
+0
–3