Philips DTR 7510 Stereo Receiver User Manual


  Open as PDF
of 60
 
Accessoriesandconnections42
Chooseonebrandcode,madeupof4digits,
fromthecodelistattheendofthismanual.
(Ifseveralcodesarepossible,gothroughthis
procedurewiththerstcodeandtryyour
remotecontrol.Ifyouarenotsuccessful,
repeat the procedure with the second code,
and so on).
Press the SELECTkeyrepeatedlyto
choose the mode corresponding to the type
ofdeviceyouwanttosetup(TV,VCR,DVD
orAmp/Tuner).
Simultaneouslypressdigits1and3untilthe
indicatorsurroundingthekeyblinkstwice
thenreleasethesekeys.
Enter the 4 digit code corresponding to the
device brand you have chosen.The indicator
surroundingthekeyblinksonceaftereach
oneoftherstthreeentries.Theindicator
surroundingthekeyblinkstwiceafterthe
fourthentry.
Ifaninvalidcodehasbeenentered,theindicator
surroundingthekeyblinksonceonly.Restart
fromstep1.
Notes
•Ifthebatterychangetakesmorethan1
minute the remote control may return to
thePhilipsdefaultsettings.Thereforeyou
havetoproceedwithanewsettingofyour
remotecontrolwiththehelpofthetable
aboveforyournon-Philipsbrandeddevices.
•Allmanufacturersareconcernedabout
theconstantimprovementoftheir
products.Althoughyourremotecontrolis
compatiblewithmostoftheequipmentof
thefollowinglist,Philipscannotguarantee
itsoperationwiththecompleterangeof
productsonthemarket
To do so:
Press SELECTrepeatedlytoselecttheSTB
mode.
Simultaneouslypresskeys1and3untilthe
STBindicatorturnsonthenreleasethekeys.
Enter code 993.The indicator surrounding
thekeyblinksonceaftereachdigitentry.
Press the VOL-/+ key.Theindicator
surroundingthekeyblinkstwice.
You have made several setting changes and you
wanttorestorethedefaultvolumecontrol
assignment settings
(see table in next paragraph)
Defaultvolumecontrolassignmentmeans:
•inTVmode,volumecontrolisperformed
through a Philips brand TV set
•inVCRmode,volumecontrolisperformed
through a Philips brand TV set
•in DVD mode, volume control is
performedthroughaPhilipsbrandTVset
•inAMPmode,volumecontrolisperformed
throughaPhilipsbrandamplieronly.
Torestoredefaultsettings:
Simultaneouslypresskeys1and3untilthe
indicatorsurroundingthekeyblinkstwice
thenreleasethesekeys.
Enter code 981.The indicator surrounding
thekeyblinkstwice.
7.3.3 Changing the brand setting of your
remote control for your TV, VCR,
DVD or Amplier
Bydefaultatrstpoweruporatrst
installation, your universal remote control is pre-
set to control your Digital Receiver as well
as most Philips brand audio/video devices.
Ifyouhaveotherbrandsofdevices,orifthe
presets do not enable you to control your
Philipsdevice,pleasefollowtheprocedure
below.
DTR 7510 200910.indd 42 16/10/2009 17:41:08
 previous next