Philips DTR 7510 Stereo Receiver User Manual


 
41Accessoriesandconnections
ENGLISH
7.3 Universal remote control
Prior to using your universal remote control,
checkorsetthefollowing:
•Device you want to control (Mode
selection)
•Volume and mute control assignment
•BrandsettingforyourTV,VCR,DVDand
Amplier
7.3.1 Mode selection (selecting the
device you want to control)
Your 5-in-1 remote control can be used to
controlmostofyouraudio/videoequipment
through various modes:
STBmodeforthecontrolofyourDigital
Receiver
TVmodeforthecontrolofyourTVset
VCRmodeforthecontrolofyourVCR
DVDmodeforthecontrolofyourDVD
or DVD Recorder
AMPmodeforthecontrolofyouraudio
tuner/amplier.
Press SELECToncetocheckwhichmode
is active.To change the mode, press SELECT
repeatedly until the desired mode is signalled by
the corresponding indicator.
The mode sequence is:
STB-->TV-->VCR-->DVD-->AMP.
7.3.2 Volume and mute control
assignment
Default volume and mute control
assignment
Foreachmode,youcanselectthedeviceof
your audio/video set-up to which volume and
mute control is assigned.
WheninSTBmode,thevolumefunctions
(VOL+/- and keys)canbecontrolled
throughyourTVset,amplier,ordigitalreceiver.
Bydefault,volumecontrolisperformedthrough
a Philips brand TV set.
When in TV, VCR or DVD mode, the volume
functions(VOL+/- and keys)canbe
controlledthroughyourTVsetoramplier.By
default,volumecontrolisperformedthrougha
Philips brand TV set.
WheninAMPmode,thevolumefunctions
(VOL+/- and keys)canbecontrolled
throughaPhilipsbrandamplieronly.
Changing the volume and mute control
assignment
Theproceduresbelowassumeyoustartfrom
defaultsettings.
YourDigitalReceiver(STB),TV,VCRorDVD
audio outputs are “all” connected to your
amplier.Weadviseyoutoassignvolumecontrol
toyouramplierforallmodes(STB,TV,VCR,
and DVD).
To do so:
Press SELECT repeatedly to select the
AMPmode.
Simultaneouslypresskeys1 and 3 until the
AMPindicatorturnsonthenreleasethese
keys.
Enter code 993.The indicator surrounding
thekeyblinksonceaftereachentry.
Press the VOL-/+key.Theindicator
surroundingthekeyblinkstwice.
From then on, whatever mode you are in, the
AMPindicatorturnsoneachtimeyoupressone
ofthe(VOL+/- and keys).
Whencontrollingthevolume,makesurethe
sourceselectorofyouramplierisproperlyset
(refertoyouramplierusermanualforsource
selection).
Note
IfyourTVsetisonlyttedwithSCART
connectors (no HDMI, no DVI and no YPbPr),
we advise you to assign volume control to your
digitalreceiverfortheSTBmode.
DTR 7510 200910.indd 41 16/10/2009 17:41:08