Filter
Top Products
Chapter 4 Settings — [PROJECTOR SETUP] menu
98 - ENGLISH
[SUNDAY]
Switches the lamp automatically on the set day of the week.
[MONDAY]
[TUESDAY]
[WEDNESDAY]
[THURSDAY]
[FRIDAY]
[SATURDAY]
Note
f The [LAMP RELAY] function is enabled when [SINGLE], [DUAL], [TRIPLE], or [QUAD] is selected in [LAMP SELECT].
f When [SINGLE] or [DUAL] is selected in [LAMP SELECT], lamps are switched at the specied time. When [TRIPLE] is selected in [LAMP
SELECT], lamps are switched three times every two hours after the specied time, and then the previous status is maintained until the next
specied time.
When [QUAD] is selected in [LAMP SELECT], three lamps light after the specied time, and three lamps to be lit are switched four times
every two hours. Eight hours after the specied time, four lamps light, and from the next specied time, three lamps are lit and switched
again.
f The operating time will be the local time. (x page 108)
[BRIGHTNESS CONTROL]
The projector is equipped with a luminance sensor to measure brightness and color of the lamp, and corrects brightness and color of the
projected image according to the changes in brightness and color of the lamp.
By using this function, in such a condition that multiple screens are displayed using multiple projectors, you can reduce changes in overall
brightness and color of the multiple screens due to lamp degradation and suppress variation in brightness and color to preserve uniformity.
Setting [BRIGHTNESS CONTROL GAIN]
Adjust the brightness when displaying multiple screens using multiple projectors.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [BRIGHTNESS CONTROL GAIN].
4) Press qw to adjust.
Operation
Adjustment
Range of adjustment
Brightness
Maximum amount of
brightness correction
Press the w button.
The screen becomes brighter.
The maximum amount of
correction is reduced.
20 % - 100 %
Press the q button.
The screen becomes darker.
The maximum amount of
correction is increased.
Note
f When using only one projector, the value obtained by subtracting the value of the [BRIGHTNESS CONTROL GAIN] from 100 % is the
maximum amount of brightness correction. Brightness cannot be corrected through brightness control since the maximum amount of
correction becomes 0 % when [BRIGHTNESS CONTROL GAIN] is at 100 %.
f Luminance will be unsteady for eight minutes after a lamp is turned on. Make adjustments at least eight minutes after starting projection.
f The result of [BRIGHTNESS CONTROL GAIN] adjustments is reected on all image signals, internal test patterns, and on-screen menus.
f The [BRIGHTNESS CONTROL GAIN] setting is enabled even if [BRIGHTNESS CONTROL SETUP] is [OFF].
Setting [BRIGHTNESS CONTROL SETUP]
Set brightness control operation.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [BRIGHTNESS CONTROL SETUP].
4) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL SETUP] screen is displayed.