Chapter 2 Getting Started — Setting up
ENGLISH - 35
Setting up
Installation mode
There are four ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD] (x page 95) depending on
the installation method. Set [COOLING CONDITION] to [AUTO]. Using the projector with [COOLING CONDITION] set incorrectly may shorten
the life of the lamp.
Mounting on the ceiling and projecting forward Setting on a desk/oor and projecting from rear
(Using the translucent screen)
Menu item Method Menu item Method
[PROJECTION METHOD] [FRONT/CEILING] [PROJECTION METHOD] [REAR/FLOOR]
[COOLING CONDITION] [AUTO] [COOLING CONDITION] [AUTO]
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Setting on a desk/oor and projecting forward
Menu item Method Menu item Method
[PROJECTION METHOD] [REAR/CEILING] [PROJECTION METHOD] [FRONT/FLOOR]
[COOLING CONDITION] [AUTO] [COOLING CONDITION] [AUTO]
Parts for ceiling mount (optional)
You can install the projector on the ceiling using the optional Ceiling mount bracket (Model No.: ET-PKD510H (for high ceilings), ET-PKD510S
(for low ceilings)).
f Be sure to use the ceiling mount bracket specied for this projector.
f Refer to the Installation Instructions of the ceiling mount bracket when installing and setting up the projector.
Attention
f To ensure projector performance and security, installation of the Ceiling mount bracket must be carried out by your dealer or a qualied
technician.