Filter
Top Products
Chapter 3 Basic Operations — Operating with the remote control
56 - ENGLISH
Switching the input signal
The input for projection can be switched.
button
1) Press the input selection (<RGB1>, <RGB2>, <DVI‑D>, <VIDEO>, <HDMI>, <SDI 1/2>) buttons.
f This operation can be also performed using the buttons on the control panel.
<RGB1> Switches the input to RGB1.
<RGB2> Switches the input to RGB2.
<DVI-D> Switches the input to DVI-D.
<VIDEO> Switches the input to VIDEO.
<HDMI> Switches the input to HDMI.
<SDI 1/2> Switches the input to SDI.
Using the Status function
You can display the status of the projector.
button
1) Press the <STATUS> button.
f The [STATUS] screen is displayed.
RGB1
---
---kHz/ ---Hz
90h
451h/ ON/
451h/ ON/
3598h/OFF/
2383h/OFF/
24°C/ 75°F
26°C/ 78°F
27°C/ 80°F
SEND STATUS VIA E-MAIL
CHANGE EXIT
STATUS
INPUT
SIGNAL NAME
SIGNAL FREQUENCY
PROJECTOR RUNTIME
LAMP1
LAMP2
LAMP3
LAMP4
INTAKE AIR TEMP.
OPTICS MODULE TEMP.
AROUND LAMP TEMP.
REMOTE2 STATUS
DISABLE
ENTER
MENU
Note
f This can be displayed from the [PROJECTOR SETUP] menu → [STATUS] (x page 106).
Using the Automatic setup function
The automatic setup function can be used to automatically adjust the resolution, clock phase, and image position when analog RGB signals
consisting of bitmap images such as computer signals are being input, or to automatically adjust the image position when DVI-D/HDMI signals
are input. Supplying images with bright white borders at the edges and high-contrast black and white characters is recommended when the
system is in automatic adjustment mode.
Avoid supplying images that include halftones or gradation, such as photographs and computer graphics.
button
1) Press the <AUTO SETUP> button.
f [COMPLETE] is displayed when it has completed without any problem.
f This operation can be also performed using the <AUTO SETUP> button on the control panel.
Note
f The clock phase may shift even if it has completed without any incident. In such cases, adjust the [POSITION] menu → [CLOCK PHASE]
(x page 74).