Filter
Top Products
Chapter 3 Basic Operations — Projecting
54 - ENGLISH
Adjustment procedure
r Relationship between the adjustment location and adjustment screws
(b) (c)
(b)+(c)
(a)
Adjustment location:
Location where the just focus point of the screen is in the
inner side of the screen
When the just focus point of
the screen in V up (top in the
vertical direction) is in the inner
side of the screen
When the just focus point of the
screen in V bottom (bottom in
the vertical direction) is in the
inner side of the screen
When the just focus point of
the screen in H left (left in the
horizontal direction) is in the
inner side of the screen
When the just focus point of the
screen in H right (right in the
horizontal direction) is in the
inner side of the screen
(a) Rotate counterclockwise ― ― ―
(b) ― Rotate counterclockwise Rotate counterclockwise ―
(c) ― Rotate counterclockwise ― Rotate counterclockwise
1) Press the <FOCUS> button on the remote control or the <LENS> button on the control panel to
display the focus adjustment screen.
2) Press s to shift the focus of the entire screen once.
3) Press the a button to stop on any part of the screen to be the first just focus point.
f For the location where focus is shifted in this state, the just focus point is on the inner side of the screen.
4) Loosen the fixed screws in the position relative to the location where the focus is shifted the most
(the location where the just focus point is shifted the most towards the inner side in Step 2)) up to two
rotations.
f Turn screws clockwise in two locations, or at least in one location when making an adjustment.
5) Slowly turn the focus adjustment screws corresponding to the locations counterclockwise and stop
where the image is in focus. (x page 53)
f If the screws are turned counterclockwise, the tilt of the lens will change by moving the lens mount bracket of the lens mounter forward
(screen side), and in the projected image on the screen, the focus point in the opposite direction of the adjustment screws will move
from the inner side of the screen to the outside.
6) Press the <SHIFT> button on the remote control or the <LENS> button on the control panel to display
the shift adjustment menu, and reset the screen position of the projected image on the screen surface
back to an optimal state.
7) Perform focus adjustment again near the center of the screen and if it is still not enough, fine tune the
amount of rotation of the adjustment screws.
8) When adjustments have been made, securely tighten the loosened fixing screws.
9) Adjust the focus again using the remote control.